![]() ![]() Under Functions, you will find IF() near the bottom. This is all nice and good, but how do we apply this to the height of our container in SOLIDWORKS? If we double-click the Height dimension, then type = on our keyboard, we get access to the Equations dropdown. That is to say: if (Length >2, make this 2, otherwise make it 1) While many programming languages form the syntax for this a bit different, the one that is most relevant to us here is how this is expressed in Excel: if(Length>2,2,1) So, if the Length > 2, then I want the height to be = 2, otherwise make the length = 1. If the length drops below 2″, I want the height to drop to 1″ (otherwise, it might be top-heavy and tip over like my Christmas tree). My container is 4″ x 6″, and it’s 2″ tall. Can any guide me how to increase font size in ANSYS Workbench. This option is appropriate when the displacements of the suppressed body are small. There are three basic options to define a remote entity: Load (direct transfer). Remote loads, restraints and masses are used to simplify the model. ![]() Since it’s difficult to describe in the abstract, I’ll assign some numbers. I am using a 32 inch screen for ANSYS Workbench but the font size is is very small. done thermal analysis or from SW Flow Simulation and in some other cases. No worries, we can still use that, but more on that in a minute. If the length is greater than a certain value, then the height increases to a different value.Īn IF statement would be great for this – except that I’m not using C++, I’m using SOLIDWORKS. The length and width can be anything, but the height is driven indirectly by the length. Hypothetical scenario: you have a design for a container wherein you have a length, width, and height. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |